New member of the club here. Fixed a couple of small issues. All three of the bobblehead coils failed, presumed from all the vibration. The plastic where the lugs are is very thin, and on each one a fine coil wire broke. I soldered those back on and coated them with hot melt. Seems to be holding up.

I also fixed the autolaunch, it was weak from interference with the manual plunger. It was a little out of alignment, and the tip of the shooter rod was mushroomed.

Cool and good looking game, seems a lot to be going on. I'm going to have to dig into some tutorials and rule sheets.

I had a problem with incomplete drop target resets, or targets falling down by themselves, even after replacing all the drop target bank springs. I found a Stern service bulletin for WPT that suggests adding washers between the target ledges and frame. I used small fiber washers and it made them reset, stay up and work perfectly. See SB165.pdf

I just updated mine yesterday.

Screenshot_20220123-044259_YouTube (resized).jpg

Screenshot_20220123-044604_Video Editor (resized).jpg

PM sent

I can help with v6.02. I don't have v6.01. I thought v6.02 was too difficult, especially for casual players and guests. I reverted back to factory, as I couldn't see any benefit to upgrading. What I really would have liked is the simplest thing: some sort of audio during the extra ball award, but it looks like that will never happen. I set all my games to 5-ball, that's about all I change.