Chantilly, VA
Are you referring to the vertical plastic that sits behind the VUK?
You can put up a protector with velcro:
https://pinside.com/pinball/forum/topic/need-advice-on-protecting-lotr
(Topic ID: 201908)
You're currently viewing posts by Pinsider DCFAN.
Click here to go back to viewing the entire thread.
It still sounds like the OP is referring to the vertical plastic rather than the Arwen plastic. The vertical plastics just needs a piece of lexan for protection that you can buy at your local hardware store and cut with a jigsaw as I posted above.
Pinbits sells a very good sandwich protector for the Arwen plastic.
Quoted from AUKraut:If the OP is talking about the vertical clear plastic on the back of the Shire VUK, then yes, that’s different. As was mentioned by DCFAN, a piece of plexiglass Lexan cut with a scroll saw attached to the inside of the VUK with some two sides 3m tape will protect that. Did that on mine and can take some pics this evening
I found that the velcro works better because the 2-sided tape has foam in between the adhesive sides and the foam tears between the adhesive outer layers over time.
Promoted items from Pinside Marketplace and Pinside Shops!
You're currently viewing posts by Pinsider DCFAN.
Click here to go back to viewing the entire thread.
Reply
Wanna join the discussion? Please sign in to reply to this topic.
Hey there! Welcome to Pinside!
Donate to PinsideGreat to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
