Quoted from Toasterdog:The .93 is smaller and grooved. You will have to replace both sides. I’ve been dealing with a similar issue for sometime on my TAF.
I couldn’t find a non-grooved replacement anywhere.
Are you sure? I noticed that too on many of the images when searching, but these seemed to be ungrooved and have the angled corners and latch in the right relative positions, unlike many others. I believe the exact parts would be 19-09-1092 and 19-09-2092.
On one of my machines it had a nice AC tap patched in between these connectors, I wanted to make a few more taps for powering various accessories like a validator or amplifier. So I need compatible connectors. I may give up on that, might be overkill anyways, but I liked the idea of easily moving the tap between machines. I might just wire in some 2 or 3-pin molex onto the pins to tap into that way.
I did ask G-P-E if he could check in on this thread already.