Quoted from Md2020:Found my left side flipper problem- pulled the SDU board with the intention of checking the K1 relay contacts but found this burnt trace instead. Love it when the problems are obvious.
Is it acceptable to just jumper it over the damaged area with wire? I know why it cooked, there were bare wires/fried solenoid on the bottom of the PF.
Not tryna make the worst hack/repair thread
[quoted image]
Those Stern flipper traces are way to thin. If the EOS is mis adjusted and does not cut the high power side those traces act like fuse. Patch with a wire and I'd do the three that are not burned too.