Wellesley, ON
Also reflow your header pins. Very very common to have cold solder cracks on the light boards.
(Topic ID: 258960)
You're currently viewing posts by Pinsider Mitch.
Click here to go back to viewing the entire thread.
Quoted from CUJO:Update:
Decided to replace the 12 Pin IDC connector with new. Punched all wires down.
All good but it's weird. If I push new 12 Pin connector down flush to board no lights work. Pull it up 1/8", all is good. So leaving it there and time will tell.
Did you reflow the solder on the header pins? I have yet to see one that didnt have cold solder joints.
The pic is the JM I did a few weeks ago every lamp board had atleast one cold solder joint.
20191214_210801 (resized).jpgPromoted items from Pinside Marketplace and Pinside Shops!
Rye, NH
You're currently viewing posts by Pinsider Mitch.
Click here to go back to viewing the entire thread.
Reply
Wanna join the discussion? Please sign in to reply to this topic.
Hey there! Welcome to Pinside!
Donate to PinsideGreat to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
