Best.
Post.
Ever.
Just finished rebuilding/upgrading my Whirlwind flippers using vid1900's instructions.
Amazingly easy. The instructions were perfect.
Vid1900 - I owe you a beer.
You're currently viewing posts by Pinsider ranhorton.
Click here to go back to viewing the entire thread.
Best.
Post.
Ever.
Just finished rebuilding/upgrading my Whirlwind flippers using vid1900's instructions.
Amazingly easy. The instructions were perfect.
Vid1900 - I owe you a beer.
Quoted from TigerLaw:Perfect timing for this bump for me. Going to do my first flipper rebuild soon on my DW.
Quoted from NM:Only place I know of Vid:
http://www.dmspinballs.com/flipper.html
Side note:
I didn't have a flipper gap tool and instead used vid1900's credit card trick to space the flipper from the brushing.
Worked perfectly.
Added bonus - I used my wife's credit card.
Quoted from bleargh:But, did you cut it to the same shape as the tool?
But of course.
Had to make sure it fit right
Quoted from TigerLaw:I see there are a couple recommendations from four months ago, but where is currently the best place to buy the full rebuild kit? I need to get three ordered pronto. Thanks in advance.
I picked up my rebuild kit from Marco (normally I shop with pinball life but i had to get a few things that only Marco were carrying at the time).
I ran into one issue with their kit.
When i was tightening down the bolt through the clamp that bites the flipper shaft, the bolt snapped.
I was livid and had to disassemble the old flipper plunger assembly and piece the new one back together.
It worked out in the end, but the metal bolts are weak. They should definitely use a stronger metal bolt – especially since you need to tighten it down enough to bend the metal clamp so it really bites into the flipper shaft.
You're currently viewing posts by Pinsider ranhorton.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/vids-guide-to-upgradingrebuilding-flippers?tu=ranhorton and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.