Can you use a twist-tie to hold the yellow capacitor in place??
You're currently viewing posts by Pinsider pinball_nate.
Click here to go back to viewing the entire thread.
One of the terminals on my flipper's capacitor seems loose (slides back and forth inside the yellow casing) - is this a problem? Can I put a dot of glue against the wire/capacitor body to keep it steady?
I will, this one is brand-new though so that's what got me wondering......?........is there play in these?
Ben, you're not making me look forwards to actually installing my new flippers once Taxi is ready???!! Did you install new switches behind the actual flipper buttons?
Quoted from vid1900:The Coil Sleeve protrudes from the Diode side of the coil. Don't put it in backwards.
Vid, is this true for ALL coils and sleeves (slingshots, pops, etc???). Thanks!!
Why the HELL are the holes in the coil lugs so DAMN SMALL!!!! If you gotta get more than one wire through there, good luck!!! (Can ya tell I've been doing a lot of soldering lately??)....
Geeeesh!
You're currently viewing posts by Pinsider pinball_nate.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/vids-guide-to-upgradingrebuilding-flippers?tu=pinball_nate and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.