Hello all. After 5 years into the hobby I finally got enough courage to clearcoat my T2 playfield. I red almost all of this topic but I still have 2 questions.
1. Those metal tubes used to allign the flippers protrude from the bottom part with about 5 milimeters. Should I take them out, do the clearcoat, drill 2 holes and put them back in or can I hammer them flat on the top side and cut them flush on the bottom and clearcoat top and bottom side with those pieces in there?
2. What to do with the bumper screws? Should I leave them there and try to go around? It will be difficult to sand on both sides because of them. Should I take them out? How? I could not find any post or picture with someone doing this part, only the install on a new playfield.
Thank you for this topic and all the knowlege that came from it.