Maybe you make new wire and trash the old ones.
Then you can cut them on to and pull them out the bottom.
That way you never have to pull up and risk lifting something. Just have to make new wires
You're currently viewing posts by Pinsider boblangelius.
Click here to go back to viewing the entire thread.
Maybe you make new wire and trash the old ones.
Then you can cut them on to and pull them out the bottom.
That way you never have to pull up and risk lifting something. Just have to make new wires
https://www.imagetoner.com/dell-c1760nw-toner-cartridges-set-im.html
Seems to good to be true.
That spring looks heavier than i remember. I have an old one from Pharaoh.
I'll send it to you. PM me.
Bob
I also have a set of 9" long drill bits. They make it easier to visually see if you are straight. Although the thin sizes flex if you are not careful with them...
You're currently viewing posts by Pinsider boblangelius.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/vids-guide-to-ultimate-playfield-restoration?tu=boblangelius and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.