Supersonic
Bally, 1979You're currently viewing posts by Pinsider arcademojo.
Click here to go back to viewing the entire thread.
Ok, who has done their homework already.
Got out of the hobby 10 years ago do to work. Finally got around to clear out my old storage.
I'm setting on about (40) Bally/Stern driver boards that accumulated over the years. I want to start rebuilding these and was hoping someone already has the part numbers and a good supplier for parts. Anyone have this already figured out? LMK
Quoted from vid1900:Everything you need is at GPE
https://www.greatplainselectronics.com/
A little costly on some parts (C23) $9.00
Question about C23 cap. Is there a minimum physical size for the cap?
looking at these. 30mm x 40mm
http://www.mouser.com/ProductDetail/Cornell-Dubilier-CDE/SLPX153M035E7P3/?qs=sGAEpiMZZMukHu%252bjC5l7Ycd%2fH5%252bMxIQfMwrK5rByu5s%3d
Quoted from vid1900:I think they were $3.50 last time I ordered, but I'm on my phone.
Size does not matter with caps.
Those snap-cap style will need some wire leads added, but otherwise should be fine.
https://www.greatplainselectronics.com/proddetail.asp?prod=CER-15000uF-25V
Out of stock.
You're currently viewing posts by Pinsider arcademojo.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/vids-guide-quick-bally-driver-board-repair-bulletproofing?tu=arcademojo and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.
