A question about the rollover cutout. Does the bit you recommend not bite into the wood? I pick up a Firepower tomorrow and already have a hardtop in order and this is the one part that that seems like it would be easy to FU.
(Topic ID: 220072)
You're currently viewing posts by Pinsider TaylorVA.
Click here to go back to viewing the entire thread.
Quoted from vid1900:The plastic is softer than the wood, so it just quickly eats away.
The wood will still have some old mastic still on it, so you will instantly feel the **tug** of when the bit touches it.
It's not something you are likely to mess up, so relax, and it will go fine.
Is there enough room for a top mount bearing guide on a router bit?
You're currently viewing posts by Pinsider TaylorVA.
Click here to go back to viewing the entire thread.
Reply
Wanna join the discussion? Please sign in to reply to this topic.
Hey there! Welcome to Pinside!
Donate to PinsideGreat to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
