has anyone put a folded pinball machine , say newer Stern into a Tesla model Y ?
You're currently viewing posts by Pinsider luch.
Click here to go back to viewing the entire thread.
Quoted from luch:has anyone put a folded pinball machine , say newer Stern into a Tesla model Y ?
any one know ?
Quoted from luch:has anyone put a folded pinball machine , say newer Stern into a Tesla model Y ?
measured one yesterday it is 27 inches tall from floor to opening , so no it will not fit , you need 31 inches to clear with head folded
Quoted from tp:Was thinking about picking up a kia seltos. Cargo opening only about 30 inches tall.
i think it will be too tight , really need about 31 inches at 18 inches left and right of dead center
Quoted from pinballjj:i have fit
You can get that inch by unbolting the 2 backbox hinge bolts from the cabinet and sliding the backbox further down towards the coindoor
is the head cable long enough to do this ?
there is so much empty space in a pin , why don't them make them 2 inches shorter when folded , would think at 26-27 inches folded , they would fit in almost any SUV
Quoted from Jay_Killjoy:Is there a list of current model hybrids or full electric vehicles that fit pins? Looking to buy a new SUV soon but want to make sure I can move a game with it.
all tesla's won't fit a folded stern , only 28.0 inches of opening , need about 30 in min
Quoted from northvibe:I have in a 2020 (same). It is a tad tight w/ the headlinder but slides in. only issue is pulling it out and getting it the 1/2" up to get over the lip.
yeah that lip is a bitch , never understand why they designed it that way
Quoted from Pinbarclay:Stern Jurassic Park does NOT fit in a 2020 BMW x3
(Creature from the Black Lagoon DOES fit, as previously reported)
i have a 2015 X3 and can get a jurasic park stern no problem , did they change the opening on the latest models ?
Quoted from JustLikeMe:Can anyone confirm if a 2018 or 2019 BMW X3 will fit a pin (B/W, modern Stern, JJP, Spooky etc) without having to remove the backbox?
i have a 2015 X3 , and they fit in my car , so don't know if the same
i believe you can , it is just that the lip of the tail gate opening is raised , so the game has to be lift up to get it out , a bit of a pain and hard on the fingers
the measurement must also be taken 15 inches from the center of the opening , because a game head is 30 inches wide , so 15 inches each side of center , then you measure the distance down , so any curved top entrance your out of luck
you must measure not in the middle but 15 inches off the dead center to the right or left , there is were you need about 30 in , remember the head is about 30 in wide folded
You're currently viewing posts by Pinsider luch.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/vehicles-that-a-pinball-machine-fits-in?tu=luch and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.