Remove and inspect for burnt GI connectors at J115, J120 and J121 on the big power driver board. if none found, pull the 5 fuses in the bottom left of the board and test them with an ohm meter.
You're currently viewing posts by Pinsider PinballManiac40.
Click here to go back to viewing the entire thread.
Quoted from i_b_flippin:it looks like my j120 and 121 connectors are burnt on the left side of connectors. What does that mean and what can I do to it from this happening again?
Heat from the incandescent bulbs put a lot of stress on the board/wired connectors. Replace the male board connectors and repin the wired connectors. Install LEDs in the GI to keep it from happening again.
You're currently viewing posts by Pinsider PinballManiac40.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/tz-gi-out?tu=PinballManiac40 and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.