Quoted from PinballHog:When I run the test all the opto checks come on as the clock runs. It also counts the hours in the test. Like 1:00, 2:00, etc. It sounds more like the motor is laboring or dragging after the hour hand gets around all the way. I didn't know if the motor might be heating up and stopping. Might be wires in a bind or shorting out. What about the board under the playfield is there anything there that might be going out, should I try resetting all the male pins on those 2 plugs?
my 'pin guy' drilled holes in the cube that houses the clock and it worked fine from then on???? so maybe a heat issue?