Twilight Zone
Bally, 1993You're currently viewing posts by Pinsider DNO.
Click here to go back to viewing the entire thread.
I had my Tz strip the wood and was not able to really get screws to grab w the normal methods.
What I did was just rotate the solenoid bracket a bit, and screw into fresh wood, worked fine, still does, location play.
If you did the same, you could just remove those screws and repair the holes.
Quoted from Marvin:just fill the holes with toothpicks or bamboo skewers. that will fix the original holes
My go-to is the Q-tip shaft, I tried and it just kept stripping and coming loose again. Wood glue gets rock hard and takes too long on location.
Grabbing fresh wood worked well, and it's under the pf anyway.
At least I didn't go the route the op has to deal with. 
You're currently viewing posts by Pinsider DNO.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/tz-are-these-screw-heads-normal?tu=DNO and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.
Highlands Ranch, CO