Make sure it's not the IDC connector, and that you don't have loose wires in the connector itself.
You're currently viewing posts by Pinsider coyote.
Click here to go back to viewing the entire thread.
Quoted from Seatmandan:I went through and re-seated the IDC wires in the connector, and it seems good. I think that the pressing on the connector to trip the switch row on or off was in the pin header, but still not 100% sure. Could the IDC connector sleeves buried in the plastic that slide onto each pin (8 of them) be bad?
Check Zaaza's continuity test, and then check for cold-solder joints, as well.
It will only by the 10 opto board if - when the switches all go dark, the Upper Left 5 Mil target does NOT respond. If it DOES respond, then the opto board's dropping out of the circuit. (Losing power, etc.) Though, pressing on the MPU won't change that, so the opto board is likely fine.
If the wires were in the wrong order, you would have a LOT MORE issues than just that one or two switches.
Well, in switch test, does the opto show open or closed?
If closed, when you wave your hand between the sensor, does it switch at all?
If it's open, then the opto (or receiver) is not getting it's power/signal from the Opto Driver board. Could be a broken wire, bad crimp on the pligs on the opto board, or a bad LM339 on the opto board. (Or, the opto could just be dead.)
If it's closed, and it opens when you wave your hand through it, then.. well, it's working.
You're currently viewing posts by Pinsider coyote.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/twilight-zone-switch-matrix-issues?tu=coyote and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.