Just finished shopping out TZ and now I have short to ground on
Row 4
Row 5
Row 6
Row 7
Row 8
Row 9
It's trying to launch a ball from automatic launcher.
Look over PF thinking something shorted, but didn't find anything.
Thoughts?
You're currently viewing posts by Pinsider Madmax541.
Click here to go back to viewing the entire thread.
Unplugged J208 get the following errors
Row 4
Ball popper opto
Clock is broken
I was getting ball popper opto and clock broken errors before.
Problem in CPU.
Just clarify
With J208 connected all are gnd to short
Row 1
Row 3
Row 4
Row 5
Row 6
Row 7
Row 8
Clock is broken
Ball popper Opto is stuck
With J208 disconnected error is
Row 4 gnd to short
Clock is broken
Ball popper opto is stuck
No row or column 9
Quoted from zaza:And when you disconnect J212 ? still GND short row 4 ?
With J212 & J208 disconnected
Check fuses F114 & F115
No row 4 error
Quoted from zaza:Could be a ground wire against the 'plumb bob' but also a problem with column2 that keeps row4 low through switch #24 'always closed' is a possibility.
Check with a jumper wire the columns and rows on the CPU-board
https://pinside.com/pinball/forum/topic/wpc-89-cpu-board-info#post-3872333
Doing this test shows gnd to short where all sw in row are activated
Check F114 & F115 both are good.
You're currently viewing posts by Pinsider Madmax541.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/twilight-zone-switch-matrix-issue?tu=Madmax541 and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.