Thanks to those that offered help on the pinbits gumball wiring.
I am finally stumped. After hours of reading threads and research, I have to ask for some insight here. The issue is with clock.... here is where we are at:
Ingo opto board
All optos check out ok per led’s/cleaned
Clock does run... motor board drives clock forward.
Connector on bottom of clock not broken... has continuity back to plug.
All boards serviced recently by Clive @ COC
In test mode the clock just runs forward. Using +/- buttons does not slow down or change direction of clock. In fact dmd says clock not running— yet it is. Optos are not registering to change the time.
My gut says we are back to some sort of board/connection issue in backbox. All boards were serviced by Coin op Cauldron recently. I checked all ribbons etc.
Anyone seen this before or have any ideas? I thought the Path of Adventure on IJ was an infuriating toy.... this thing takes the prize.
Thanks
N