You're currently viewing posts by Pinsider amxfc3s.
Click here to go back to viewing the entire thread.
Quoted from Barr993:In the midst of my first under ramp cleaning, is this plastic supposed to be bent like this?
[quoted image]
I added a picture of mine below
Quoted from amxfc3s:mine seems slightly bent but not that much
Quoted from PinballAir:My question is: what do you suppose the post office does with all that treasure that they have no idea what it goes to?
Quoted from PinballAir:Anyone have trouble with LEDs being too tall for the pop bumpers.
Did a full rebuild with everything new.
The 555s fit fine. The LEDs fit in one but not the other two.
All light sockets are the same.
I suspect 2 of the bodies are shorter than the third. One is bright white and the other 2 are not as bright.
Are there 2 heights for pop bodies?
Use bulbs without the dome or bend the socket slightly to the side so they fit.
Quoted from Mad_Dog_Coin_Op:Yes, especially if it is original. Replace the capacitor on your opto board.
This. Not saying it's your issue but it should be done. They like to leak and eat traces on the PCB.
Quoted from GILV:Thanks for the advice, I'll do them then, where do I buy those and do I need to replace all of the smaller resistors as well on the board.
I almost made the same transister mistake in this post.
Mouser, digikey, arrow, ect will all have the cap. The resistors are probably fine but are cheap if you want to have spares on hand.
You're currently viewing posts by Pinsider amxfc3s.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/twilight-zone-owners-club?tu=amxfc3s and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.