You're currently viewing posts by Pinsider Boltronix.
Click here to go back to viewing the entire thread.
Can anyone tell me where this wire goes on my TZ? It is the yellow wire in pin 9. From there to a connector. At that connector there are 2 yellow wires coming out the pin. The other wire is short and looks like it broke off at solder connection?
The connector goes up to the clock optos i think. Two of the new rainbow leds are not working.
It be a great help!
Thanks in Advance
IMG_2097 (resized).jpgIMG_2098 (resized).jpgI could have said there are two yellow wires coming out of the connector in the first photo. one of them goes two pin 9 on the opto board shown in the photo. The othe wire coming out of the connector in the first phot is hanging loose, not connected, looks like it was soldered some where.
Thanks for following this, Walt
Hey Squeakman,
Can you look at the few post above and tell me where that wire goes? (take a photo?) I will check out the plastic tips.
So I get the error "check f115, f116, j112 and 12v opto supply". All check out good. What to check next? First I am going to take out INGO's new rainbow clock and install my old clock. I checked all wires to clock and custom opto board and have not found anything. the custum opto has 12vdc with the lit LED.
You're currently viewing posts by Pinsider Boltronix.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/twilight-zone-owners-club?tu=Boltronix and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.