Check clock gears, make sure they're not gummed up and binding. check voltage to your Motor control board under the PF. (Off-hand, I cannot remember if it should be +20v or +12v, but it should be one of those.)
(Topic ID: 303693)
You're currently viewing posts by Pinsider Coyote.
Click here to go back to viewing the entire thread.
Quoted from locksmith:Removed all gears cleaned and lightly lubed. Measured 16.4 volts in test mode. Speed is pretty fast in test mode.Game play is the kick in the balls.This problem will test your nerves but the fix if I find it will be sweet.
If you can, get a video of it in test & game mode?
That feed should be the flasher +20vu feed; on my game it sits at about 24v. 16.4 is awfully low. Are your flashers dim? (And not LEDs - LEDs will be bright no matter the difference between 16 & 24 volts)
You're currently viewing posts by Pinsider Coyote.
Click here to go back to viewing the entire thread.
Reply
Wanna join the discussion? Please sign in to reply to this topic.
Hey there! Welcome to Pinside!
Donate to PinsideGreat to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
