Quoted from AvidPinPlayer:

Thanks Crispy. I took your idea and modified a bit. It works great! Balls still drain through these outlines, but not as much. Below are photos of right & left outlines with the modification.

TWD Left.jpg 108 KB

TWD Right.jpg 178 KB

Quoted from skywalker:

I curse Borg for this frustrating design, the Middle divider should be as far up as the top sling post, the side drains are woeful, even my wife has asked me to mod this area somehow, well done on the mini post setup, I'm reluctant to change anything as this is how it was designed, would like to see the audits on side drains & games played, nudging forward does help a lot, wait & see

Quoted from AvidPinPlayer:

Its just a piece of a metal clothes hanger, cut to meet the height of the pin's plastic post and bent to loop around the screw that goes through the plastic post. If you loop the wire correctly the tightening of the screw will pin the wire next to the plastic post. Then add whatever rubbers you want, that is, a rubber post, or O ring. Ensure the correct alignment in order not to block the in/out lanes.