Quoted from Frax:It would not work. At the LEAST it would need a completely different connector setup, and more likley, it would need a total re-write of the lamp status detection code since there is no "lamp matrix" to read under the Spike system...they're using a serial bus.
You are right, but I think there will be a pretty straightforward solution not long after release. You can determine the mode through lamp or flasher sequence, so even if getting the serial data is too hard (Eli today is grabbing data as it comes TO the Power driver board), you can always get to the power that's actually driving the lights or flashers. I'm sure someone will come up with a solution that will work for SPIKE.
-Wes
Post edited by copperpot: Missed a )