Hi, quick favor/ask of the community. Anyone with a Tron Pro with an OEM Stern SAM Shaker motor installed? I just cannot find the 3 pin male connector with brown/white wire in the backbox anywhere. Any tips, suggestions? Did some of these versions come without the appropriate wiring?

The other wire down by the shaker motor is there and available, it's pre-tapped and drilled for the shaker and shaker board... What am I missing? Could you show me a pic?

Thanks!

Thank you both! I tried to delete this thread soon after I created it. Upon further investigation, I found that page 1 and 2 of the instructions contradict each other. Page 1 says the 3 pin brown white wire is in the backbox, while page 2 says it's in the bottom/back of the cabinet. That's where I found it, in the back of the cabinet, laying on the bottom just after the second support behind the cab speaker.

Well if I can't delete the thread at least it may be helpful for someone else searching the topic in the future in case they too pick up an OEM shaker from Marco.