I have one of the older 5V OLED/LED screens from the original mod in the old style Tron kits. Long story short, I bought a 12V splitter from pinball pro to run a ticket dispenser. I wasn’t thinking that the Screen runs on 5V and not 12V and when I hooked it up to the new splitter I was running 12V through it. The screen ran for about 30seconds and obviously burnt out. Is there anything I can do to save the screen? Chips to replace, etc?? If not, were can I get one reprogrammed/ replaced, any recommendations would help.
Also, word to the Wise, research and buy a splitter that just does both 12V/ 5V. Not only did I ruin my OLED screen the ticket dispenser uses both 12V and 5V so I have run another molex line through the splitter anyway. What a waste.
thanks
Scott
Detroit Pinball