Ok I am having problems with my TOTAN, when all the golden symbols are hit the magic carpet at the bottom of the ramp is lit and the princess calls out shoot ramp to collect.
As the ball goes up the ramp the diverter should open and let the ball go into the fore ball magnet to collect the Jewel.
This has stopped happening, the diverter has stopped opening so a Jewel can't be collected that way. Iv checked switch 15 and the solinoid which works the divertor and both work fine.
Please can sme one help

Thankyou Simon

Yes I have checked that, it opens and closes correctly. Any uther suggestions.

Ok iv done the checks stated by noitebe1, still no joy it's quite bizar as the divertor does open when the purple diamonds are lit and a Jewel is then awarded. It won't open though when the magic carpet is lit and the princess calls shoot ramp to collect ( as it should do )
any more thoughts on this would be much appreciated.

No Thankyou I will test all those switches, would they not show up when the machine is switched on with an error message?

Finally sorted my problem on TOTAN out swooped the ramp switch, playes perfect now, noitbe1 for your help.

Hi guys
Am having problems with the GI 2amp fuse blowing on each game play. Any help in trying to locate the problem would be much appreciated.

F0AF303B-CB33-47F1-89E2-F527C2CDEA68 (resized).jpeg

Thankyou for your help, I have now found the culprit. It was a crockadile clip from a mod fitted touching.
Something so simple.
Thank you for your advice.
Regards Simon

Iv got two problems with my TOTAN, the first is my coin light is out iv swopped the bulb and still out, is it normal to be the holder?
The Second is the R on the BAZAR it been dim for a while again I have swooped the bulb and holder on this one but still no joy. If it is the diode could some one please tell me what size I require?

Coin slot, iv tested back to J2 white-violet
then from J2 back to J 104 on the PDB and I am not getting a voltage.
Any thoughts? would anyone recommend bypassing and linking into another sauce?

Ok is that with one probe on the pin and the other probe to ground.?

Ok iv tested both single cables white-violet and violet individually from J104 back to the bulb holder in the coin slot both are good for continuity.

Ok, that would make sense, iv never took one off before might be a bit to big of a job for me. Thankyou

Hi
Does any one have a diagram or can tell me the correct layout of the hex spacers on the ramps,
the previous owner of my TOTAN has re installed them incorrectly.
Many thanks