Before:
giphy-1.gif
After:
giphy-2.gif
Ok, so after about 4 hours of tweaking, removing, installing, and repeating I finally got the ball to hit the right flipper as it should and bounces to the left. Here is what I had to do, hopefully, this can help others if they run into this.
This game has a Mantis bazaar scoop, and these scoops tend to have uneven leg heights. In my case the two legs on the right (looking at it with the playfield up) were short. HEP had installed a couple of washers to compensate... but that was not the issue... entirely.
1. I removed the scoop and first slightly bent the top lip as it was not straight.
IMG_4264 (resized).png
2. Slotted the upper left hole to allow more rotational movement to aim at the right flipper
washers (resized).png
3. Added a very unique stack of washers to both the right legs. The top required slightly thicker washers than the slotter bottom right.
WBOJ5376 (resized).png
Whew... that was a lot anyway, think we are good to go now but haven't actually played a full game yet haha.
Also noticed the scoop has a metal lip that was rather tall and probably just a matter of time before it damages the balls or a ball gets stuck so I ground this down.
lip (resized).png