Quoted from Md2020:Ended up walking away. Upon arrival, I immediately saw the "slash feature" on the cracked G ramp was not functional and the linkage was down in the cabinet. Obvious outgassing on the DMD. What really got me was the driver board..... Looks like a ton of heat all over. Browned out/blackened heat exposed chips- ESPECIALLY above the large "blue" resistors. Below those, I found a missing tiny resistor with wire just hanging off the board and heat/and or explosion damage? I knew right then that I wouldn't be able to even plug this thing in without possibly blowing something else up. The fellow wanted 5g's right off the bat. He has offered to get it working before I purchase it. Even if he gets it working, I'm not sure it's worth 5k. Full fucking shop out, AT LEAST. It's very filthy. Idk, as much as I read this back and realize I dodged a bullet, I still had a hard time walking away from it. I wonder if this would be one of those offer 3 as-is situations? He didn't seem to want it to walk out below 5, but he knows it needs a shitload of work. This guy is a friend/operator going through hard times, and I want to help him out, but this GnR is ROUGH
Sounds like you went with your gut and made a good decision. I wouldn't be surprised if this dude offers it to you for a lot less if he comes to his senses.