Payment sent!
You're currently viewing posts by Pinsider dudah.
Click here to go back to viewing the entire thread.
Have a problem with mine. Under the trunk test the game is reporting a trunk error. In trunk test, trunk barely moves.
Looking under the game, the motor is stuck powered on trying to go counter clockwise (perspective from the underside of the playfield). I unplug the motor cable from the Leon board and rotate it with my hand. All optos register in switch test and trunk test. Trunk eddy registers. Opto interruptor set screw is in the indentation in the trunk post which aligns with the trunk hole at the top. As soon as I plug the motor in it tries to go CCW and never stops on any opto.
No matter what I do, whenever I plug the trunk motor in, it rotates counter clockwise. I plug the motor directly into the motor controller board and it still wants to rotate CCW. The LED on the motor controller board is always on. Try rotating the interruptor to each opto to see if it will stop and no dice. As soon as I plug the motor board into the Leon board, I hear the relay click and the red one LEDgoes on for a split second then turns off and the green LED stays lit. Never had this issue before. Any ideas?
Based on the latter, perhaps it's a bad motor controller? I noticed there was a tiny scratch at the top of the 14 pin IC, but nothing that should affect it. And again, before I put in the Leon board, had zero trunk issues.
Quoted from pinballinreno:Put the old board back in and see if the problem persists? Check the condition of all/any IDC connectors.
They all look good on the playfield end, didn't check the driver board. The old board only does the optos which that aspect is working fine. I'm suspecting the motor control board at this point. However, it's very strange that this happened right after installing the Leon board. Game is at a buddy's house, will investigate.
You're currently viewing posts by Pinsider dudah.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/tom-trunk-error-leons-fix-anyone-done-this?tu=dudah and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.