I am looking at motor bushings for Theatre of Magic. I see the following two parts listed at Marco:

http://www.marcospecialties.com/pinball-parts/A-19933
and
http://www.marcospecialties.com/pinball-parts/02-5157.1

Is the rolled pin in the first link necessary? The reason I am asking is that when I was cleaning the gearbox I noticed that the pin was snapped off on my bushing. I tried drilling it out with no luck. I went to look for a replacement part and found the two at the links above. Marco says the only difference is the rolled pin ($21+ difference in price????). If the rolled pin is needed does anyone know what size and where to get one? Since only the second link is in stock I am going to order that and see what happens. Anyone had to deal with this bushing and the pin? Thanks.

I used a .093 extractor tool for the connector to the magnet. Do you know what the size of the smaller pin going to the green light are? When I cleaned the gearbox I unsoldered the light, but it would be easier to extract the pins from the connector and just pull the tube up through the trunk.
My choices look like .062 or .156 (I am not to up on Molexology). Anyone know where to get them other than at Marco prices?
While I am waiting for a new bushing I'll search out an extractor tool. Then find that rolled stop pin.
Thanks for the feedback.