You're currently viewing posts by Pinsider ronkz650.
Click here to go back to viewing the entire thread.
A coil is wound wire that will read very low ohms. Pretty hard to tell a bad coil from an ohm meter reading unless it reads open. If the coil is actually shorted, which is doubtful unless it's melted, most the time the drive transistor is also bad.
Go into solenoid test, select this solenoid, then check the volts. During test should read 50-75vdc on one lug of the coil all the time, and the other lug drops low as the game attempts to fire the coil.
You're currently viewing posts by Pinsider ronkz650.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/tom-dead-trough-coil?tu=ronkz650 and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.
Sandy Springs, GA