Can I suggest a rework on your TAF bookcase graphics?
Seriously disappointed in the one I purchased and here's why (and how to improve upon it).
1.) The bookcase flooring - tightening down the posts to even just snug causes material to twist and contort where it actually causes the graphics to lift on the edges. Easily fixed by enlarging the post holes to match the outer diameter of the bottom of the post.
2.) The book case graphic piece is too thick, the top side hole measurements are wrong. - This would be better suited to be laminated with a much thinner material. It doesn't take abuse and should be cut into several pieces that don't stop you from being able to repair/replace the opto board. Not to mention because of the thickness it doesn't want to lay down properly on the edges. The length of this graphic needs to be increased ~ 1/4" so the graphics cover the entire top side and then down to the base of the floor. Re position the screw holes.
If my request falls on deaf ears I'd be more than happy to pay a few bucks for the actual artwork so I could print my own. Hit me up on PM if you'd like.
Thanks,
Chris