Quoted from drfrightner:

I do NOT like these game blades for Wonka. You're inside the factory and your game blades look like the outside of a factory.
You need the inside of the factory, we need the chocolate river, the boat is missing from the game, tons of candy, lollipop trees, gummy bear trees, blah, blah and maybe over all that is the factory interior.
I buy game blades for all my games but I'm not a fan of these. I hope you can do a second version.

Quoted from Jimmyhonda:

Yes, the wet method is best. Use a spray bottle with water and a drop of dish soap. Spray the back of the side blade. Then install. The water/soap will allow you to move it around or restick into place until it’s perfect. Once in place, smooth it out the best you can and get any access water out. Good luck. This method works everytime!!

Quoted from KingBW:

Remove the playfield, with someone else helping, and set it next to the pin on saw horses (no need to disconnect anything but mods with short wires). That's my method (along with the wet apply method) with 2 people applying the side blades to keep it all aligned and haven't had a problem. Did about 6 pins so far.[quoted image]