How about some JP2 mods other than the yellow hazard lines? Flipper toppers or speaker grill, etc?
You're currently viewing posts by Pinsider Jimmyhonda.
Click here to go back to viewing the entire thread.
Quoted from Rager170:Anyone have suggestions for best way to install the side blades? I have a set coming from Tilt shortly.
I have had nothing but bad experiences installing these in the past ha (not from Tilt).
Yes, the wet method is best. Use a spray bottle with water and a drop of dish soap. Spray the back of the side blade. Then install. The water/soap will allow you to move it around or restick into place until it’s perfect. Once in place, smooth it out the best you can and get any access water out. Good luck. This method works everytime!!
Quoted from Rager170:Unfortunately getting help, especially with everything going on, is not an option.
You can easily do it alone. The drop of soap and water mix let’s you move it around and reposition if needed. Easy peezy. I’ve done 7-8 sets by myself this way. You can put a few drops of soap for a larger spray bottle. A very small spray bottle only needs 1 drop or 2. It doesn’t really matter that much. As long as there’s a little soap. Don’t over think it. Good luck!!
You're currently viewing posts by Pinsider Jimmyhonda.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/tilt-graphics-inc-mods?tu=Jimmyhonda and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.