I am busy rebuilding my DMD Printed Circuit Board using the kit from Great Plains, I did the one on my FT & TZ awhile back and all worked out great, however today I noticed on this board in position C11 instead of the little yellow capacitor there is a green resistor, I had a look at the circuit diagram in the manual which says C1, C2 & C11 should be 1KP 50V, I had a look at C1 & C2 and it is the same looking resistor, it certainly looks like a resistor as it has the coloured bands around it, it also looks like it is factory standard as it does not look like it has ever been worked on since original assembly, does anyone have any idea what is going on here.