Hi guys.

My trunk is kinda loose, I mean I can turn it like a half an inch with my hand. So that means during gameplay, the ball can knock the trunk out of aligment, and it won't turn at all. To me it seems like the center rod is not tighten enough, is there a way to tighten the center rod???
And, is it a true nightmare to take the trunk assy out???

Cheers

I'd like to show you guys but i dont know how to upload video clips

Thanks a lot for your inputs guys, I found this pic online, and it looks like the center rod has at least 2 of these tightning screws, so I'll have to work my way down from the top of the trunk by removing the wires and see if I can get access to the tiny screws
Let's hope I dont have to go inside the gearbox

Sunday project

DSCN0292 (resized).JPG

Problem solved
Had to open the gearbox and tight these two screws.
Trunk now spins very well
Thanks guys

28537349_2080875048595379_1924665194_n (resized).jpg

Mank, if you have a perfectly working ToM pin, would it be too much to ask if you could please take a pic for me with the trunk case off and lemme see the center rod, I'd like to see it's position (the gap in the bolt) mine is pointing at 9 o'clock, but i think it's still a tiny tiny bit off mark...
Remember to turn the game on before you take the pic, so the trunk will go into it's correct position for gameplay

DSCN0292 (resized).JPG

No, I didn't but I did tight those two screws pretty well, it ain't moving now, and after 23 years of use, these are almost bound to come loose sooner or later, but for now I think it'll hold for many years.

Yes, the gearbox had plenty of grease, and all the cogs are getting lubrication

...I've been playing a few rounds now, and the trunk behave as it should, spins around to the correct sides when that's needed, also the magnet for multiball, it lifts the ball, spin around and drop it, then return to the jackpot position