My pin is missing the left ramp exit guard and as it is impossible to find (in stores) I decided to make my own.
I hoped that I should be able to re-purpose a ramp guard that was close to what I needed from some other pin and after looking around a bit I saw the "01-15200.1-2 STAR WARS E1 (Williams_ Bracket-large ramp end)". Get it here https://www.marcospecialties.com/pinball-parts/01-15200.1-2
Note: There are two SW protectors, make sure to get the one with the correct curve!
I took a chance and ordered it.
The protectors curve fit nicely, but the arm is obviously too long.
Marked where to cut it off.
After cutting. It's not super round but it's decent enough.
Measured hole position and used a metal drill (that metal was pretty hard to drill).
Screwed to pin and whoaaah, fits like a glove!
Looks great imo.
All in all, the metal works took about 30-40 minutes in total, not bad for making an unobtainable part.
Edit: an unexpected advantage of having the ramp protector is that the ball doesn't "bounce" back up once before falling down (as it always did for me without it). This makes the game feel a tiny bit faster/smoother for me.