(Topic ID: 46571)
Linked Games
Shadow, The
Bally, 1994
Topic Gallery
You're currently viewing posts by Pinsider tzben.
Click here to go back to viewing the entire thread.
1 month later
Quoted from MagicMako:Can anyone tell me if the ball rests directly against the plunger in the shooter lane on their game? The ball comes to rest about 1/8in away from the plunger on my game and im wondering if that's why it doesnt consistently make it all the way up the initial wireform ramp that puts the ball in play when I launch the ball.
If you ball isn't making it up the launch wireform consistently make sure the plunger tip is flat and not angled. Just file it down if needed.
11 months later
Quoted from DefaultGen:New owner here. My machine is basically perfect except I'm getting glass striking airballs 1/3 times a ball launches. I have tried tightening screws and bending the wire slightly down, but I don't think that's the issue. The issue is a couple of small divots in the wireform, the ball is getting air when hitting these.
Pretty annoying. I'm going to try to smooth over the bump with JB Weld to see if that's a quick fix. If that doesn't work I might try a weaker plunger coil. Anyone else have wear here?
It doesn't look like much but if you roll a ball over it there's a definite bump.Check the shooter tip. Is it flat? Mine was uneven with wear n tair. M
Just file it flat.
1 year later
I use reinforced targets from Pinball resource. Still get airballs on location though. I normally try to backhand that ramp, much easier.
1 year later
I've been getting a lot of rejects when I hit a good shot into the mini play field vertical launcher hole. What is normally the cause of this? too bouncy rubbers on the posts?
2 years later
Quoted from daveddd14:I haven’t seen a “ battery holder” like this, is this safe enough off the board or would you have NVRAM installed?
just use lithium AA's. They aren't going to leak
2 years later
Promoted items from Pinside Marketplace and Pinside Shops!
Myrtle Beach, SC
You're currently viewing posts by Pinsider tzben.
Click here to go back to viewing the entire thread.
Reply
Wanna join the discussion? Please sign in to reply to this topic.
Hey there! Welcome to Pinside!
Donate to PinsideGreat to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
