Working on a Shadow. Can anyone look at this picture and tell me where these wires go??? They are green/orange and white/yellow playfield switch wires. BUT those wires are already going to J207 and J209. So...are they broken off from the connectors? If so, I'll install new connectors and trifurcon pins. Just want to make sure before I do so...don't want to blow the switch line. Anyone that can snap a picture of their shadow and post, I'd much appreciate it.

20181129_180736 (resized).jpg

Thanks so much. I seen those connectors in the head of the game, but the manual shows that J206 and J208 are not used. So the manual is wrong. Thanks again. Really appreciate the help.

So every Opto is acting goofy. When I go to switch edge test, the game just goes through all the Opto switches. I pulled the Opto board from the bottom of the game and re flowed the header pins. Didn't change anything. Looking at the test report, it shows magnet Opto faulted. Would one Opto cause all of them to act up? The only one that shows in test report is the magnet one. I guess I'll start there. Is there diodes on these optos? If so, then maybe the one on the magnet Opto is bad...and sending power back through the rest of them? Sorry Just thinking out loud here, but if my theory seems correct, can anyone confirm?

Thanks. I'll pull the board again and check the diodes.

I'll look at that too. Thank you