Quoted from Blitzburgh99:

I cleaned up the lockdown bar assembly and putting new decals on it. Can anyone post a pic or tell me what the stickers on the left and right say? I have the "Install 5 Balls" and "hazard" decals figured out. Thanks!

Quoted from PhillyArcade:

Anyone ever run into balls getting stuck in the trough assembly? First time I've seen this one. I was playing and noticed the ball would not kick out. I looked down and no ball waiting in the trough to shoot up. A little wiggle and the balls roll on top of the coil and it shoots up. Thinking it was an opto issue, I pulled the opto boards and re-flowed solder on everything (can't hurt and saw some crack solder) but I noticed where the balls would sit and rest typically, there is small dings in the bottom of the trough where each ball would sit. Those little divots are just enough to cause my issue. I hit the bottom of the trough with a scuff pad and some wax and it helped just a little bit. I see Marco sells an upgraded trough. I guess I'll have to get some heavy duty sand paper in there or just buy the upgraded one. First time I've seen this.

Quoted from daveddd14:

Hey guys I am sending out another game board for NVRAM and decided to look at my Shadow to see if I wanted to send both out. I haven’t seen a “ battery holder” like this, is this safe enough off the board or would you have NVRAM installed?

Quoted from SNES:

The DMD was starting to mess up (6 or so vertical lines going through it) so I thought maybe it was starting to fail. Made half a joke about now I get to upgrade to color! Anyway, as the night progressed the DMD went completely out with the exception of a few small dots on the bottom. I started a game and there was no sound.