Here's an update on my issue.
I isolated the drop down coil in a number of ways to diagnose the problem. In short, the fuse only blows when the drop down coil is hooked up. the coil immediatley heats up when the machine is turned on and pops the fuse. I have tried removing it from the drop target bracket and letting it hang in the machine separate from the bracket just in case there was a short there. Same blown fuse. I have clipped the wires on the drop down solenoid and plugged in the molex that powers both the drop up and drop down solenoids and the fuse doesnt blow and the drop up solenoid works fine. I have unplugged the drop down and drop up solenoids and plugged in the magnet only and the fuse doesn't blow.
There is one solenoid running from the Orange-Grey wire. The Drop down solenoid
There are only 2 solenoid running from the Red-Grey Wire. the Magnet and the Drop down
The drop down solenoid is run from Orange-Grey and Red-Grey from the fliptronics 2 board
My drop down solenoid doesn't have a diode installed on it and from the manual it looks like its not supposed to.
I have also tried reversing the wires on the drop down solenoid and it still heats up and pops a fuse.
Hope this info helps diagnose a little further