Quoted from PtownPin:My comment wasn't intended to sell the game short in anyway. I hope your right, but 5000 is a lot of games....
Yeah, I buy a JJP LE because I think the extras are worth the additional $$, not because of it's limited nature.
You're currently viewing posts by Pinsider Jvspin.
Click here to go back to viewing the entire thread.
Quoted from PtownPin:My comment wasn't intended to sell the game short in anyway. I hope your right, but 5000 is a lot of games....
Yeah, I buy a JJP LE because I think the extras are worth the additional $$, not because of it's limited nature.
Quoted from Bmanpin:I do agree but it’s a large chunk of change. Normally if you were to buy a car people would be there to help you fix it correct? Also would not have to fix it yourself correct?
Maybe it's different where you live but I have to bring my new car in if it needs service.
Quoted from Motorcitypinball:The part # shows it is a Williams/Bally FL-11722 from Pinball life.
Just want to make sure its ok to use this?
Like Lloyd said, the driver transistor is probably bad. The transistor often fails due to a poorly connected or bad protection diode.
If you just replace the coil, make sure to monitor that coil when you first turn the machine on. If it immediately locks on, shut off the machine before the new coil burns up. Then disconnect the coil and contact JJP support for a new board.
Quoted from Motorcitypinball:thanks that sounds like a plan.
Are you referring to the main board? Is the diverter resistor on the main board?
I don't see schematics for GNR, but if it's the same as Wonka, the drive 'transistor' is on the IO PCB Assy, All Drives Populated (ADP) board 15-004001-01.
Quoted from punkin:The other side is different, it only has two bits. this side has 4 or 5 bits. But the gaps and stuff look the same to me each time i adjust it. i can't tell the difference.
I really would like to replace them with better switches that don't bend and have a proper contact pad though. I don't want to be pulling the playfield up 5 times a day.
I don't think I've seen any other complaints with that issue, so doesn't sound like a design flaw. Perhaps someone can take a photo of that area on their machine for you to compare.
Quoted from romulusx:We will just say our goodbyes now?
Lol 24 cans a day?
That sounds like a lot, but if you say it's one beer an hour, doesn't sound so bad.
Quoted from cybevenom:Kinda stumped. Cannot seem to get the tilt function to work. Some say thats a good thing but i like to play the game it was meant to. When i even put the tilt bob against the ring it should tilt i would think. Followed the wires and as far as i can see they run straight to the backboard connector. reseated that and checked the pins. The pins are seated correctly as i can see. All checks out. Anyone else had this problem and perhaps a fix? Game came out of the box this friday like this.
Does the switch matrix in diagnostics show anything?
You're currently viewing posts by Pinsider Jvspin.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/the-official-jjp-gnr-thread?tu=Jvspin and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.