I finally added the four figures to my LOTR POTD and got them at working with the corresponding lights. My cost was under $100. $60 for the figures, $32 for the plastic with posts and bolts from pinbits, $5 for the green LEDs with resistors inline off of eBay, and miscellaneous wires, plugs z connectors, and diodes. (You could knock $25 off of that if you had some PETG or acrylic plastic and cut your own plastic.) I added a 5 volt led inside each figure with a restrictor and a diode on a positive side. I made a Y plug and wired them off of the five wires going to the common and 1 2 3 4 POTD lights. The 1 2 3 4 POTD yellow wires go to the positive side of the LED. The one common wire goes to the negative side of each LED. (Took me three times to get the darn thing wired right. See my prior post above.) Attached is a wiring diagram of how I ran the wires. After the wires were in place I put them in green shrink tubing. I ran the wires down the posts and underneath the POTD and out through the hole for the POTD wires. I also attached a couple of pictures with the lights on and the lights off. Finally because these figures come 3 in a pack, I have two left over that I'll sell to anybody for $15 each plus shipping.