Genesis
Gottlieb, 1986You're currently viewing posts by Pinsider hisokajp.
Click here to go back to viewing the entire thread.
Quoted from That-guy-again:Yup i just order a window from ven. Its all coming together. I just need to think what i might want to do with the lights
Anyone know where i could find a replacement window? Mine is pretty much cracked everywhere :/
Quoted from yfz450:Reach out to pinside member Ven. He made one for me that was a perfect fit, laser cut and all the holes lined up perfect. Not sure he is still doing these though.
J.
i did, a couple time but he has never replied unfortunately 
Quoted from yfz450:Reach out to pinside member Ven. He made one for me that was a perfect fit, laser cut and all the holes lined up perfect. Not sure he is still doing these though.
J.
Did you replace the foam washers from under the window? mine are like half missing, any good choices?
Quoted from Canad-eh:This may be a question for the System 80 thread but here goes...
While playing , after the 3 drop targets fall the solenoid fires them up/reset and immediately blows the 1A fuse (F14) under the playfield . I wanted to ask before diving in to cut out , test diodes . I do not posses a schematic as of yet , new game to me .
Thanks
right, i would assume a bad diode on the coil that reset the drop target bank, can you try with another coil?
Quoted from Canad-eh:I de soldered the diodes from both coils in that circuit, both were good . Tested the coils and no change in resistance with them removed either.
Could I use a 2A fuse in there?
i odn't have the manual at hand but i would not go above spec. if a new fuse is still blowing then there is too much resistance in the circuit. could something be shorting/touching the drop reset coil? Any other coil you can quick swap for a full test?
You're currently viewing posts by Pinsider hisokajp.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/the-genesis-club?tu=hisokajp and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.
Redmond, WA