Great concept! Looking good so far!
Quoted from Mbecker:Here's what I ended up with on my 1st attempt. (This is after hours of bending) -- what a pain in the ass! I still don't have them quite right but it's close. It turns out it's super difficult to bend wire in one axis while maintaining them straight in another axis. (ie, my z-axis was getting goofy while I was bending the wire in the x and y axis's).
It should work out good.. but it's some difficult work I wasn't expecting.
Do you have one of these? http://www.marcospecialties.com/pinball-parts/77-8593