Quoted from djreddog:

I don’t have pics readily available of my Dirty Harry, but on all of my games with ramps or lock shots that have posts like that I also replace with fat rubbers. See my T2 below as an example.

Quoted from djreddog:

I don’t have pics readily available of my Dirty Harry, but on all of my games with ramps or lock shots that have posts like that I also replace with fat rubbers. See my T2 below as an example.

Quoted from MT45:

So does anyone know what spacer or sleeve is used ABOVE these bell or taper post sleeves?
I cut some custom ones from some old straight post sleeves I had around but I’m sure there is a standard part.
In the image below (not my game) it’s the milky white colored thing above the yellow tapered post sleeve

Quoted from Scoot:

Hello everyone! I have finally purchased my first pin and it is no other than Dirty Harry. Very challenging machine I have to admit, as it took me 20 or so games just to get a replay. But was so excited to do so. The ramps are so tough and hitting a ricochet is insane. I’m loving this game the more I play it. The pin hasn’t been serviced or even cleaned for 15 years, but the guy I bought it from was super nice and I think I got a great deal.
I am adding a few things like leds and new rubbers, and was thinking about adding either decals or mirror blades. Which would look better? I already have on order the back decal.

Quoted from Scoot:

Thought I'd touch up the safe house and warehouse a little bit. They looked a little blah.

Quoted from Scoot:

I decided to install my cliffy protectors last night with much reservation. Four hours, three beers, and two bloody fingers later, I finally got them installed. After I put everything back together, I proceeded to rack up my best score yet. The pinball gods must have had pitty on me. So totally worth the hassle.

Quoted from Kensurfs:

Dirty Harry Topper finally finished. Smith & Wesson Model 29 (replica), Police Badge, Harry Callahan ID Card, 44 Magnum Speed Loader.

Quoted from PAR:

So I've resolved several issues on my project DH, to the point where the game boots and plays. Now I'm chasing down other problems. On power up/boot, the auto plunger coil pulses 4 times, also ocassionally the gun launch will do the same. I know these are on the same voltage connection #2 & #3. One thing that I am wondering about since they can both be actuated by the ball launch switch, gun handle trigger switch 11, and I assembled this project from parts, is there a diode missing from the mix some where that I failed to account for?
Thoughts and advice appreciated!