I've recently picked up a R&B and have noticed that the 'Hat Trick' shot (left orbit diverted to a VUK) bounces back about 50% of the time. I was curious if other owners experience this and if there is a known fix before digging into it.
Thanks!
You're currently viewing posts by Pinsider nomonkey.
Click here to go back to viewing the entire thread.
I've recently picked up a R&B and have noticed that the 'Hat Trick' shot (left orbit diverted to a VUK) bounces back about 50% of the time. I was curious if other owners experience this and if there is a known fix before digging into it.
Thanks!
Quoted from JoshODBrown:I would check the coil and mech for the diverter to make sure it is opening up far enough and long enough to allow the ball to be diverted into the VUK. if the sleeve or linkage/coil stops or something are not in great condition, I could see it partially opening and causing the ball to not make it in there.
Also, any obstructions in the path to the VUK? Game is not set too steep? Flippers are powerful enough to launch the ball around the orbits normally?
Thanks for the reply. I should have mentioned that this was after rebuilding all coils, mechs, top-side teardown/clean. The diverter works well and directs the ball no problem. It's just at high speeds it appears to bounce off of the back bracket above the hole to send it off at an odd angle. I'll just tweak on the guides around the hole. Probably just need to square them up a bit.
You're currently viewing posts by Pinsider nomonkey.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/that-trick-never-works-rocky-bullwinkle-club?tu=nomonkey and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.