Terminator 2: Judgment Day
Williams, 1991Replaced a power driver board in a t2 with a new rotten dog board, after installing it I’ve been blowing fuse f103 and f104 not sure if I’ve hooked something up wrong (could well be I did) but I took all the pictures before hand.
And I don’t see anything out of place but maybe with the new board I’ve done something wrong
Rotten dog is after swapped image
Thanks again!!
50552C9E-DD34-4D62-88C8-E2D2D686F053 (resized).jpegEA9D4598-818D-4B8C-BCE1-B917B67714FB (resized).jpeg
Regardless of this I’d get those factory ribbon cables out of there before trying to troubleshoot any further.
Quoted from nitrocow:Replaced a dmd driver board in a t2 with a new rotten dog board
It is a Power Driver board. Rottendog has not had quality boards. Printing on the board "DMD driver board" shows their attention to "quality".
What is wrong with your original Power Driver board? Pretty much can be fixed cheaper than the new board costed.
Quoted from nitrocow:The connector has been replaced at some point on j126 if I move it over either way one pin is off. I’m assuming the black/brown wire should be on the right most pin?
I don't have my game here to confirm the J126 connection matches the manual.
pasted_image (resized).png
https://www.ipdb.org/files/2524/Williams_1991_Terminator_2_Judgment_Day_Manual.pdf
Quoted from PinballManiac40:Printing on the board "DMD driver board" shows their attention to "quality".
I thought that it was labeled with WDB-089 but I see old images with the current labeling. I assume it is labeled this way because it is a "General Purpose Driver Board for DMD Games". Asterisk next to DMD corresponds to list of games below in the silkscreen.
Oh, now we are here, J120 GI is wired wrong. In the picture the Brown and Orange string are combined on the Yellow string.
J126 and J106 need a new IDC/Molex. J115 is a bit scary.
Quoted from DumbAss:General Purpose Driver Board for DMD Games
Funhouse, Harley Davidson and The Machine are AlphaNummerics. Better call it a General Purpose PDB for WPC/WPC-s
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/terminator-2-dmd-fuse-issue- and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.
Friday Harbor, WA