I recently purchased a Tee'd Off, and found that the GOPHER wheel only registers the bottom set of 'GOPHER' letters when the ball lands on it. In addition, the right outlane and sometimes the top switch for the 'Hurry Up' (next to the 'Pitch n' Putt' ramp) will activate when the right flipper is activated. The right flipper also acts as is it's being 'held down', but this only registers on the DMD when in menus and for initials. Everything works well until the Gopher wheel activates. I've given it a bit of lube and made sure the contacts were all in the corresponding lanes for each letter. This is my first pin, so I've been racking my brain to figure out where to go next. Any help or suggestions would be greatly appreciated.