I know this has been covered. Just seeing if there is anything else I should check. Bottom flippers were pretty weak. I rebuilt them and added new eos switches. I cleaned the cabinet switches..although they still look bad. I will replace them next. It has a rottendog flipper board. I've reseated the connectors.
After this, the right bottom seems ok. I've had a tftc before both bottom flippers were a lot stronger. The right flipper can make the left ramp.
The left flipper is still a little weak. I can't fully make the vertical right ramp. It doesn't seem like its just using the holding voltage...just seems a touch too weak.
What next?